Steam Cycle Information; Steamfresh; Reduce Static; Easy Iron - LG DLEX8388WM Training Manual

TRAINING MANUAL DLEX8377WM

STEAM CYCLE INFORMATION

The steam dryer is designed to provide the power of steam through the introduction of
steam into almost every drying cycle.
™

STEAMFRESH

™
The STEAMFRESH cycle is a 20-minute cycle that tumbles the clothes in a spray of
steam. This cycle is NOT a wash cycle, but is instead designed to refresh clothing that
has been packed away, stored, or otherwise wrinkled and less than freshly laundered. The
steam cycle will refresh from one to five items during its 20-minute run time. The drum
tumbles the clothes while steam sprays through them for the first five minutes. Then the
steam continues while the drum tumbles for 2 seconds once each minute. At that point
(12 minutes in to the cycle,) the steam generator is turned off and the dryer continues
to tumble constantly with the main heater engaged to finish drying the clothes. The main
heater is turned off for the last two minutes of the cycle while the drum continues to
tumble to allow the clothes to cool.
The MORE TIME and LESS TIME buttons are used to adjust the number of items to be
™
freshened during the STEAMFRESH cycle.
The time cannot be adjusted by the user when a sensor dry cycle is engaged.

REDUCE STATIC

The REDUCE STATIC cycle is an add-on to all the regular cycles except AIR DRY or
RACK DRY. When REDUCE STATIC is selected, the main heater is turned off two minutes
before the end of the cycle and the steam generator is energized for the final two
minutes while the drum continues to turn.

EASY IRON

The EASY IRON cycle is an add-on to all the regular cycles except AIR DRY or RACK DRY.
When EASY IRON is selected, the main heater is turned off eight minutes before the end
of the cycle and the steam generator is energized for the final eight minutes while the
drum tumbles for two seconds once a minute.
CHILD LOCK can be engaged only after a cycle has been selected and the START button
has been pressed. CHLD LOCK locks ALL controls, including the POWER button. It
releases at the end of the cycle or in the event of a power failure.
DLEX8388WM Page 20 STEAM DRYER