Cisco RV180 Administration Manual page 44

Configuring Networking
Configuring the LAN (Local Network) Settings
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Cisco RV180/RV180W Administration Guide
Enabling VLANs
Choose Networking > LAN (Local Network) > VLAN Membership.
Check the Enable box.
Click Save.
Under the Enable VLAN field, The VLAN Membership Table is shown. This shows
available VLANs, including the VLAN ID, description, ports, and whether inter-
VLAN routing is enabled or not for each configured VLAN.
Creating a VLAN
You can create up to four VLANs on the Cisco RV180/RV180W.
Choose Networking > LAN (Local Network) > VLAN Membership.
In the VLAN Membership Table, click Add Row.
Enter a numerical VLAN ID that will be assigned to endpoints in the VLAN
membership. The VLAN ID can range from 2 to 4093. VLAN ID 1 is reserved for the
default VLAN, which is used for untagged frames received on the interface, and
VLAN ID 4094 is reserved and cannot be used.
Enter a description for the VLAN.
To enable routing between this and other VLANS, under Inter VLAN Routing, check
the Enable box.
To enable device management, check the Device Management box. This allows
you to access the Device Manager from that VLAN. For example, if you created a
VLAN with the VLAN ID of 2 and enabled device management, you can access the
Device Manager by using the first IP address on the created VLAN (for example,
192. 1 68.2. 1 ).
Under each of the ports for the VLAN, choose one of the following:
• Tagged—Used when connecting to switches carrying multiple VLANs.
• Untagged—Access ports connecting to end devices like printers and
workstations.
Click Save.
2
35