Husqvarna FS 513 Operator's Manual page 29

LUBRICATION:
Depth Control Grease Fitting (X): A grease
fitting allows lubrication of Blade Depth Control
(EE) screw. To access this grease fitting:
• Raise the Diamond Blade (H) to maximum height.
Open Tool Compartment (BB), temporarily remove opera-
tion manual bag.
• Grease fitting (X) is located near top of Blade Depth
Control (EE) Tube.
• Add Grease to the fitting. Raise and lower the machine
a few times to circulate the grease through the tube.
• Replace Operation Manual Bag, close Tool Compart-
ment (BB) door.
Engine Oil:
Checking Engine Oil:
Check that engine oil level is correct. FS 
ONLY: Start the engine and let it idle for  or
 minutes. Stop the engine and wait for  or 
minutes. See engine operation manual for more
information.
FS 513:
Engine Oil Dipstick (Z) is located on front of
engine. Refill engine oil in dipstick hole. When
checking oil level, Engine Oil Dipstick (Z) should
not be screwed in. See engine operation
manual for more information.
FS 520 / FS 524:
Engine Oil Dipstick (Z) is located on front of
engine. Refill engine oil in oil filler hole (see en-
gine operation manual). Fully insert Engine Oil
Dipstick (Z), then remove it to check oil level. If
the oil level is low, remove the oil filler cap, and
fill to the upper limit mark on Engine Oil Dipstick
(Z) with recommended oil type. See engine
operation manual for more information.
Because engine often operates at an angle,
check oil level with engine horizontal. Check
frequently to ensure that oil level never falls be-
low lower mark on dipstick. 0W0 oil is recom-
mended. See engine operation manual for more
information.
MAINTENANCE & LUBRICATION
FS 513
FS 520, FS 524
9