Midi Control - Behringer Xenyx UFX1204 Quick Start Manual

30
XENYX UFX1204
Recording to USB drive in STAND-ALONE mode
Step 7: Recording
(EN) Transport Control Feature Chart
to USB drive in
Show Remaining Time
STAND-ALONE
Show Sampling Rate
mode
Select Sampling Rate 44.1 kHz
Select Sampling Rate 48 kHz
Toggle PLAY<>PAUSE
Toggle Recording Mode (e.g. "001") <>
Playlist Mode (e.g. "P01")
Toggle Single Playback ("Pxx") <>
Continuous Playback ("cxx") [only in Playlist mode]
FAT-formatting the USB drive*
Delete current song (in Recording Mode)*
*press PLAY to confirm / any other button to abort
Error Codes:
DrP
FSE
oFF
SLO
Although USB sticks and 2.5" USB-powered external drives could work, the use of powered hard drives for direct recording with the internal USB
recorder is recommended.
Press TIME REMAIN short
Push and hold TIME REMAIN button until the
sample rate is displayed
Push and hold TIME REMAIN until the
sample rate appears and then press while still
holding TIME REMAIN
Push TIME REMAIN until the sample rate
appears and then press while still holding
TIME REMAIN
Press PLAY (to start) > press PLAY (to pause)
> press PLAY (to continue) > etc.
Push TIME REMAIN + for two seconds
Push PLAY for two seconds
Press together STOP + for two seconds
Press together PLAY + for two seconds
Dropout while recording. A summary of the total
number of dropouts will be displayed after recording
(e.g. d03).
File system error. Incompatible file system on the drive.
Drive must be formatted by the UFX.
No external USB drive is recognized or connected.
The connected USB drive has been specified as
too slow. No recording will be possible.
31
Quick Start Guide
Using the MIDI CONTROL Features
Step 8: Using the
The TRANSPORT CONTROL section on the UFX1204
(EN)
can operate as a MIDI controller in one of two modes:

MIDI CONTROL

STANDARD MIDI MODE or MACKIE CONTROL MODE.
Features
The Mixer must be turned off.
To select STANDARD MIDI MODE, hold
, turn the power on, then release
when "Std" shows up in the display.
To select MACKIE CONTROL MODE, hold
power on, then release
in the display.
For STANDARD MIDI MODE, map the
transport controls in your recording
software to the TRANSPORT CONTROL
buttons on the UFX1204. In MACKIE CONTROL MODE,
set your recording software to follow the
appropriate protocol.
,
, turn the
, when "MAC" shows up