Gain Setting - Behringer Xenyx UFX1204 Quick Start Manual

26
XENYX UFX1204

Gain Setting

Step 4: Gain Setting
Press the Channel 1 SOLO button.
(EN)
Press the MODE button under the
VU METER in the main section to allow
the METER to operate in PFL (pre-fader listen) mode.
Sing, Speak, or play at a normal level
through the microphone or instrument
connected to Channel 1.
While singing or playing, turn Channel 1's
GAIN knob. The VU METER will display
the signal level. Set the GAIN so the
loudest peaks reach 0 on the VU METER. Press the
Channel 1 SOLO button again.
Repeat steps 1-3 for any other channels
that will be used.
27
Quick Start Guide
Multi-FX Processor
Step 5: Multi-FX
Your mixer has a built-in effects processor.
(EN)
Follow these steps to add effects to one or
Processor
more channels.
Turn the FX knob up halfway on each
channel you would like to add an
effect to.
Turn the FX SEND and FX RETURN knobs
to "0". You may adjust them later.
Make sure the FX ON button is
pushed in.
Scroll through the effects by turning
the FX knob.
Adjust the intensity of the effect
turning the edit knob.
If using presets 1-8, 13-14, or 16,
press the TAP/SELECT button to toggle
between two different values
(light off/on) for the second parameter. To adjust
the delay time of presets 9 and 15, hit the
TAP/SELECT button several times in the tempo
of the music piece. Similarly, hit the TAP/SELECT
button several times to adjust the modulation
speed of presets 10-12. The button will start
flashing in the corresponding tempo.
Readjust each channel's FX knob to
make sure the right amount of effect
is added.