Behringer Xenyx UFX1204 Quick Start Manual page 13

24
XENYX UFX1204
XENYX UFX1204 Getting started
Step 3: Getting
Make sure the power to all devices is
(EN)
turned off.
started
Connect all appropriate power, audio and
FireWire/USB cables to the mixer.
Set all faders to the down position,
PAN/BAL knobs centered and all other
knobs (except EQ) all the way left.
Turn the mixer on.
With the MAIN MIX fader, PHONES,
CONTROL RM, and ALT 3-4 knobs all the
way down, turn your PA system or
powered monitors on.
Slowly raise the MAIN MIX fader, PHONES,
CONTROL RM and ALT 3-4 knobs to 0 or
the desired level.
See "Step 4: Gain Setting" for more information.
Adjust the level of connected
microphones and instruments by raising
each CHANNEL FADER.
25
Quick Start Guide
Adjust the left-right position of a channel
in the stereo field if necessary by turning
the channel's PAN or BAL knob.
MAIN MIX fader. If the CLIP LEDs on the
VU METER light, lower the MAIN MIX fader.
Adjust the COMP knob to add
compression to an input if necessary.
For live applications, adjust the overall Use the channel AUX knobs and master
output from the mixer to the power AUX SEND knob to send the channel
amp or powered speakers by raising the signals to an effects processor or stage
monitor connected to the AUX SEND jacks. If used
for effects, route the signal back from the processor
to the AUX RETURN jacks.
VIRTUALIZER 3D FX2000
EUROLIVE F1320D
active oor monitor