Low-Speed Data Communication - Icom IC-2820H Instruction Manual

5
DV MODE OPERATION (Optional UT-123 is required)

■ Low-speed data communication

In addition to the digital voice communication, low-speed data
communication is available.
The optional OPC-1529R
rial data communication software
quired in addition.
NOTE: Turn OFF the GPS data communication
advance to operate the low-speed data communication.
D D Connection
Connect the transceiver to your PC using with the optional
OPC-1529R as illustrated below.
to [DATA]
OPC-1529R (optional)
57
and se-
DATA COMMUNICATION CABLE
are re-
(purchase locally)
(p. 127)
to RS-232C
D D Low-speed data communication application
setting
Configure the low-speed data communication application as
follows.
• Port
in
• Baud rate
• Data
• Parity
• Stop
• Flow control : Xon/Xoff
D D Low-speed data communication operation
NOTE: Confirm that in AUTO, the computer controls when
[PTT] is active, so that you can send data without pressing
[PTT] on the radio.
qSet your own, station call signs, etc. as described in
"■ Digital voice mode operation"
peater operation"
wRefer to the instructions for the low-speed data communi-
PC
cation application.
e To transmit data.
• At the same time as voice audio, push and hold [PTT] to transmit
while sending data from the PC. Release [PTT] to receive.
• Under computer control, see Transmission condition setting at
right.
: The same COM port number as IC-2820H's
: 9600 bps
(fixed value)
: 8 bit
: None
: 1 bit
and "■ Digital re-
(p. 39)
.
(p. 42)