Table of Contents
Advertisement
NOTE: A serial computer connected to a port other than Port 1 of
Module 1 cannot access configuration mode for its module while the
master configuration port is configuring a module.
NOTE: If a computer attempts to configure a feature that is only
accessible to the master configuration port, Port 1 of Module 1, the
computer will be sent this message by the Model 24SII DES:
This Option is accessible via Port 1, Module 1 ONLY.
Strike any Key to continue
NOTE: If a computer port other than the master configuration port
attempts to access configuration mode of a module that it is not
connected to, the Model 24SII DES will ignore the configuration
request and create a print job consisting of Control-T , C, and the
module number.
CAUTION: If you have a M24SII-V07 installed as Module 1, do not
configure Port 1 of this module for any baud rate higher than 115,200
or you will locked out of configuration mode and unable to program
the various features of the Model 24SII.
Advertisement
Table of Contents
