Table of Contents
Advertisement
* If you set Oscillator Type to DOUBLE (double oscil-
lator program) in "Page 2: Oscillator basic/Oscilla-
tor 2 relative", these pages will display either the
oscillator 1 or oscillator 2 parameters. Switch
between oscillators 1 and 2 by pressing the VARIA-
TION buttons [1] and [2].
Page 1: Program play
In Page 1 of Program mode you can select the Program
that will be played. You can also use the Performance
Edit settings that are shown in this page to perform
simple editing.
Press the PROGRAM button to enter Program mode,
and the following display will appear.
Program
Program
[A11...E88, F11...F88, Dr11...Dr28]
The internal memory of the iS35 contains seven banks
of Programs, as follows.
Number of
Bank
programs
A
64
B
64
64 × 3
C, D, E
F
64
Dr
16
12. Program mode
Transposition/Octave
Contents
GM programs 1–64 (ROM)
GM programs 65–128 (ROM)
iS35 preset programs (ROM)
User programs (RAM)
Drum programs (ROM: Dr11–26,
RAM: Dr27–28)
How to recover lost changes
If you accidentally select a different program without
writing your edits, you can press the TEMPO
(if you have not yet edited the selected program) to
bring back the previous program. (Only the sound will
be brought back, and the program number will not
change.)
Select the program with the buttons in the PROGRAM
section (see "Changing the sounds of the keyboard
tracks" a pagina 36). Select a bank (A, B, C, D, E, F-
USER/DRUM) and enter a two-digit number with the
number buttons. You only need to enter the two-digit
number if the program is contained in the same bank.
In order to select a Drum program (Dr11–28), press the
F(USER/DRUM) button repeatedly in the PROGRAM
section, until the abbreviation "Dr" appears, then
select a two-digit number with the number buttons.
You can also select programs using an optional foot-
switch or an EC5 external controller pedal. For details
refer to Disk/Global mode "Page 14: Assignable
pedal/switch" or "Page 15: EC5 external controller".
When you select a program, a MIDI program change
message will also be transmitted.
XPOSE (Transpose)
[–11...+11]
When you need to transpose (shift the pitch), use the
TRANSPOSE buttons to set the Transpose setting of
each program. The pitch can be transposed in semi-
tone steps over a range of 11 steps up or down.
Octave
[–2...+2]
Use the OCTAVE buttons to set the Octave of each pro-
gram. With a setting of 0, the program will sound at its
standard pitch. The pitch can be shifted in steps of an
octave, over a range of 2 octaves up or down.
Reference • Program mode
button
169
Advertisement
Table of Contents
