General Operating Instructions - Chicago Electric 92158 Owner's Manual & Safety Instructions

General Operating Instructions

Switch (48)
Figure 3
1. Loosen the Angle Adjusting Screw (49) and adjust the Bracket (22) to the desired angle for sanding.
2. Plug the Power Cord (52) into a GFCI-protected electrical outlet.
3. Securely grasp the tool handle (with both hands) and press the Switch (48) to the On (I) position.
4. Begin sanding with light movements and pressure until the sanding
capability is known on the material being sanded.
5. When finished using the Belt Sander, press the Switch (48) to the Off (O)
position. Wait until the motor stops before setting the tool down.
6. Unplug the unit from the electrical outlet.
7. To prevent accidents, turn off the tool and disconnect its power supply after
use. Clean, then store the tool indoors out of children's reach.
Item 92158
Angle Adjusting
Screw (49)
For technical questions, please call 1-800-444-3353.
Slide Lock (36)
Loosen Sanding Belt
Adjusting Screw (59)
Sanding Belt Tracking
Bracket (22)
Page 11