Setting Up The Monitor; Installing The Monitor Pedestal Base; Connecting The Monitor - HP Compaq L1506x User Manual

Hide thumbs Also See for Compaq L1506x:

Table of Contents

Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other

attached devices, then follow the instructions below.

To install the monitor pedestal base:

Place the pedestal base on your desktop or table and check to be sure the arrow on the

underside of the base is facing forward.

NOTE:

mounting fixture; instead refer to

Using both hands, position the monitor over the pedestal base and press down firmly to lock the

pedestal base in place. When the base locks, it will make a clicking sound. Make sure the

pedestal base is securely locked before continuing with the setup.

Figure 3-1

Place the monitor in a convenient, well-ventilated location near the computer.

Connect the monitor signal cable on the back of the monitor to the video connector on the rear

panel of the computer.

Chapter 3 Setting Up the Monitor

Do not install the base if the monitor will be used on a wall, swing arm, or other

Inserting the Monitor into the Pedestal Base

Mounting the Monitor on page

ENWW

Table of Contents