Installing The Driver And Raid Utility - HighPoint RocketRAID 4320 User Manual

Mac OSX Driver

1 Installing the driver and RAID utility

Installing the package
1. Double click the package labeled "rr3xxx-mac-v120-113007.dmg" to start the
installation process ("xxx" refers to the revision of the driver). This will open the
driver and software package.
2. Double click the "RR3xxx_4xxx-mac-v122-080421.dmg" file to start the installer.
3. When the Installer window opens, click the "Continue" button.
4. The installer will ask you to select a destination for the driver. Make sure to select
the boot Volume - the driver must be installed to /System/Library/Extensions/
folder in order to function properly.
5. Click the "Install" button.
You will be prompted: "clicking the install button will install a basic installation of
the software package on your selected volume". Confirm the prompt to install the
software package.
6. You will then be notified that a reboot is needed to install the software. Click
"Continue Installation".
7. The driver will then be installed into the system. Click "Restart" to restart the
ystem.
After the system restarts, you can use a web browser to configure the controller and
setup RAID arrays. Use the MacOSX Disk Utility to create partitions the RAID arrays.
Web RAID Management Utility
Please refer to page 5-1 – the Web utility utilizes a universal interface, and operates in
the same manner as revisions released for other operating systems.
8-1