Husqvarna Viking Eden Rose 250C Limited Edition User Manual page 28

Restart the Buttonhole?
If you are sewing a buttonhole and stop to adjust the length
settings you will get this question once you start sewing
again. If you select "Yes", the machine will restart and sew
the buttonhole from the beginning with the new settings.
If you select "No", the change will be cancelled and the
machine will continue sewing the rest of the buttonhole
with the previous settings. Use the arrow buttons to select
"Yes" or "No" and press the OK button.
Sensor One-Step Buttonhole Foot line up -
"Adjust white area to white line"
When you insert the fabric for sewing a buttonhole, the
wheel of the Sensor One-Step Buttonhole Foot might
move. A pop-up message prompts you to line up the white
area with the white line. Line up the white areas and close
the pop-up message by pressing the OK button.
Sensor One-Step Buttonhole
Presser Foot connected
The Sensor One-Step Buttonhole Foot can only be used
for the buttonhole stitches recommended for the foot. If
the Sensor One-Step Buttonhole Foot is connected and you
select a stitch that is not possible to sew with the foot, this
message will appear when you start to sew. Remove the foot
or select a buttonhole that can be sewn with the Sensor
One-Step Buttonhole Foot. Close the pop-up message by
pressing the OK button.
Machine Set for Free Motion Sewing
This message is shown when the machine is set to Free
Motion Floating or Free Motion Spring Action and you
turn on the machine. Close the pop-up message by pressing
the OK button.
Main Motor Overload
If you are sewing on very heavy fabric or if the machine is
blocked when sewing, the main motor can get overloaded.
The pop-up message will close when the main motor and
power supply is secure.
28 – Operating the machine