Programming - Husqvarna Viking Eden Rose 250C Limited Edition User Manual

PROGRAMMING

The Programming function on your machine makes
it possible to create stitches with your own personal
settings and to combine stitches and letters into stitch
programs. You can add up to 40 stitches and letters
in the same program. Save your own stitches and
programs in My Stitches and recall them any time you
like.
All stitches in your sewing machine are programmable
except for buttonholes, darning, button sewing and
bartacks.
Create a Stitch Program
1. Press the PROG button to open the mode for
Programming.
2. The stitch menu which was previously selected will be
kept when entering the Programming mode. To change
the stitch menu, press the Stitch Menu button and select
another stitch menu by using the arrow buttons.
3. Press the number of the stitch you wish to use. The
stitch will appear in Programming Mode.
4. Press the number of the next stitch and it will appear to
the right of the last entered stitch.
Note: Two numbers are displayed above the stitch program on the left
side of the GraphicDisplay. The fi rst number is the position of the
selected stitch in the program. The second number, put in brackets, is
the total number of stitches in the program. The number above the
stitch program on the right side of the GraphicDisplay is the number
of the selected stitch.
Add Letters
5. Press the Font Menu button. Use the arrow buttons to
select a font and press OK. The machine will show the
upper case alphabet in Programming Mode.
6. Use the arrow buttons to select a letter and press OK to
add the letter to the program.
7. To switch to a lower case alphabet or numbers press the
Shift button.
About Programming Letters
Both upper and lower case letters will be stitched with a
7 mm stitch width. If there are letters going below the
baseline included in the program (e.g. j, p, y) the height of
the uppercase letters will be reduced.
All text to be sewn out on the same project, should be in
the same program to ensure the letters are sewn out in the
same height.
For instance, a name and an address should be in the same
program with a STOP after the name.
22 – Operating the machine
Programming Mode
4.
6.
"Husqvarna" and "VIKING" have been programmed separately.
"Husqvarna" and "VIKING" are in the same program.