Listening To The Radio - Sharp HT-CN300H Operation Manual

Listening to the radio

1
Press the ON/ (STAND-BY) button to turn the power on.
2
Press the TUNER/BAND button repeatedly to select the desired
frequency band (FM ST, FM or AM).
3
Press the or button to tune in to the desired station.
Manual tuning:
Press the or button as many times as required to tune in to the desired sta-
tion.
Auto tuning:
When the or button is pressed for more than 0.5 seconds, scanning will start
automatically and the tuner will stop at the first receivable broadcast station.
Notes:
When radio interference occurs, auto scan tuning may stop automatically at
that point.
Auto scan tuning will skip weak signal stations.
To stop auto tuning, press the or button again.
When an RDS (Radio Data System) station is tuned in, the frequency will be
displayed first, and then the RDS indicator will light. Finally, the station name
will appear.
Full auto tuning can be achieved for RDS stations "ASPM", see page 31.
To receive an FM stereo transmission:
Press the TUNER/BAND button to display the "ST" indicator.
" " will appear when an FM broadcast is in stereo.
FM stereo mode indicator
FM stereo receiving indicator
If the FM reception is weak, press the TUNER/BAND button to extinguish the "ST"
indicator. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/ (STAND-BY) button to enter the power stand-by mode.
02/6/17 HT-CN300H_(E)4.fm
HT-CN300H
27