Tv Tuner Module Cable - HP HDX 16 Maintenance And Service Manual

TV tuner module cable

✎
The TV tuner module cable is included in the Cable Kit, spare part number 496481-001.
Before removing the TV tuner module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Optical drive (see
b. Hard drive (see
c. TV tuner module (see
d. Memory module (see
e. WLAN module (see
f. Switch cover (see
g. Keyboard cover (see
h. Keyboard (see
i. Speaker assembly (see
j. Display assembly (see
k. Top cover (see
l. Audio/infrared board (see
Remove the TV tuner module cable:
1. Remove the TV tuner module cable connector 1 from the clip in the base enclosure.
2. Remove the TV tuner module cable 2.
Reverse this procedure to install the TV tuner module cable.
Removal and replacement procedures
"Battery" on page
"Optical drive" on page
"Hard drive" on page 4-11)
"TV tuner module" on page
"Memory module" on page
"WLAN module" on page
"Switch cover" on page
"Keyboard cover" on page
"Keyboard" on page 4-24)
"Speaker assembly" on page
"Display assembly" on page
"Top cover" on page 4-39)
"Audio/infrared board" on page
4-8).
4-9)
4-13)
4-15)
4-16)
4-18)
4-20)
4-30)
4-31)
4-50)
4–52