HP Compaq nx5000 series Maintenance And Service Manual page 161

❏
❏
❏
❏
❏
❏
2. Remove the six PM2.5×5.0 screws 1 that secure the system
board to the notebook.
3. Remove the PM2.5x11.5 screw 2 that secures the hard drive
connector to the system board.
4. Use a 5.0-mm socket to remove the two HM5.0×9.0
standoffs 3 that secure the system board to the notebook.
Removing the System Board Screws and Standoffs
Maintenance and Service Guide
Display assembly
Top cover (Section
Speaker assembly cable
LED board (Section
Bottom board
Any Secure Digital (SD) cards in the SD Card slots
Removal and Replacement Procedures
(Section 5.16)
5.17)
(Section
5.20)
(Section 5.21)
5.19)
5–53