Replacing The Light Bulbs - GE Profile PVM9179 Owner's Manual And Installation Instructions

Replacing the light bulb.
Convection Combination Convection
Bake Fast Bake Roast
Reheat
Defrost
Weight/Time
Cancel Start
Off Pause
Lock Controls
Hold 3 Sec
Timer Cook Set
On/Off Time Clock
Options Help
Surface
Turntable Vent Fan
Light
Remove screw.
Microwave
Popcorn Beverage
Express
Warm Power Auto
Level Cook
Convection Combination Convection
Bake Fast Bake Roast
Reheat
Defrost
Weight/Time
Cancel Start
Off Pause
Lock Controls
Hold 3 Sec
Timer Cook
On/Off Time Clock
Options Help
Turntable Surface Vent Fan
Light
Plastic Color Panels
Use a clean, soft, lightly dampened cloth, then dry thoroughly.
Door Seal
It's important to keep the area clean where the door seals against the microwave. Use only mild,
non-abrasive detergents applied with a clean sponge or soft cloth. Rinse well.
Bottom
Clean off the grease and dust on the bottom often. Use a solution of warm water and detergent.
Cooktop Light/Nite Light
Replace with a 120 volt, 40 watt (max.)
halogen bulb. Order WB08X10051 from your
GE supplier.
1 To replace the cooktop light/nite light, first
disconnect the power at the main fuse or
circuit breaker panel, or pull the plug.
Set
2 Remove the screw from the side of the light
compartment cover and lower the cover
until it stops.
3
Be sure the bulb is cool before removing.
Break the adhesive seal by gently
unscrewing the bulb.
4 Screw in the new bulb, then raise the light
cover and replace the screw. Connect
electrical power to the oven.
GEAppliances.com
27