Replacing The Light Bulbs; Stainless Steel - GE c-|10E Owner's Manual

Replacing the light bulb.
Remove screw.

Stainless Steel

Do not use a steel-wool pad; it will scratch the
surface.
Shake bottle well.
Place a small amount of CERAMA
BRYTE ® Stainless Steel Appliance
Cleaner on a damp cloth or damp
paper towel.
Clean a small area (approximately
8" x 8"/20.3 x 20.3 cm), rubbing with
the grain of the stainless steel if
applicable.
Dry and buff with a clean, dry paper
towel or soft cloth.
Repeat as necessary.
NOTE: If a mineral oil-based stainless steel
appliance cleaner has been used before to
clean the appliance, wash the surface with
dishwashing liquid and water prior to using
Cooktop Light/Nite Light
Replace with a 120 volt, 40 watt (max.) halogen
bulb. Order WB08X10051 from your GE supplier.
1 To replace the cooktop light/nite light,
first disconnect the power at the main
fuse or circuit breaker panel, or pull
the plug.
Remove the screw from the side of the
2
light compartment cover and lower the
cover until it stops.
www.GEAppliances.ca
the CERAMA BRYTE ® Stainless Steel
Appliance Cleaner. After washing the
surface with dishwashing liquid
and water, use a generous amount
of CERAMA BRYTE ® Stainless Steel
Appliance Cleaner to clean the appliance.
To Order
To order CERAMA BRYTE
Appliance Cleaner, please call our toll-free
number:
Parts Department
www.GEAppliances.ca
CERAMA BRYTE ®
Stainless Steel Appliance
Cleaner . . . . . . . . . . . . . . . . . . . . . . . . . .# 40616EF
Be sure the bulb is cool before
3
removing. Break the adhesive seal
by gently unscrewing the bulb.
4 Screw in the new bulb, then raise the
light cover and replace the screw.
Connect electrical power to the oven.
® Stainless Steel
1-800-263-0686
27