Toshiba B-EX4T2 SERIES Owner's Manual page 121

APPENDIX 1 MESSAGES AND LEDS
LCD Message
No.
Display of error message
20
(See Notes.)
21 POWER FAILURE
22 EEPROM ERROR
SYSTEM ERROR
23
24 DHCP CLIENT INIT...
25 RFID WRITE ERROR
26 RFID ERROR
27 LOW BATTERY
28 INPUT PASSWORD
PASSWORD INVALID
29
Please Power OFF
30 INTERNAL COM ERR
NOTE: When an error message listed above appears on the LCD display please refer to Section 5
TROUBLESHOOTING for a solution.
LED Indication
ONLINE ERROR
A command error has occurred
while analyzing the command.
A power failure has occurred.
Data cannot be read from/written to
a backup EEPROM properly
When the following abnormal
operations are performed, a
system error occurs:
(a) Command fetch from an
incorrect address.
(b) Access to word data at an
incorrect address.
(c) Access to long-word data at an
incorrect address.
(d) Access to the area of
80000000H to FFFFFFFFH in
the logic space in user mode.
(e) An undefined instruction in an
area other than a delay slot
was decoded.
(f) An undefined instruction in a
delay slot was decoded.
(g) An instruction to rewrite a
delay slot was decoded.
DHCP Client is being initialised.
(Only when the DHCP is enabled.)
The printer did not succeed in
writing data onto an RFID tag after
having retried the specified number
of times.
The printer cannot communicate
with the RFID module.
The voltage of the Real Time Clock
Battery is low.
The printer is waiting for a
password to be entered.
A wrong password was entered
three consecutive times.
A hard error occurred in internal
serial interface.
EA1- 2
APPENDIX 1 MESSAGES AND LEDS
Printer Status
ENGLISH VERSION EO1-33094
Acceptance of
Restoration by
Status Request/
RESTART key
Reset Command
Yes/No Yes/No
Yes Yes
No No
No No
No No
----- -----
Yes Yes
No Yes
No Yes
No No
No No
No No