Panel Sets And Trim Sets - Quadra-Fire 5100-I Manual

STANDARD
831-1452, Gold Trim
SP-51S-NL, Nickel Trim
Kit Includes: (2) Side Panels, left & right; (1) Panel Top & Fastener package; (2) Side Trim, left & right; (1) Trim Top & Fastener package.
Tools Needed: Powered Phillips head screw driver and a long handled Phillips screw driver .
Attaching Panels to the Insert
1. Loosely install the 2 side panels, do not tighten, using the
cage nuts already attached to the stove. (Note: The sides are
not interchangeable).
2. Put top panel in place pushing straight back and then to the
right to lock onto top of side panels. Attach the top panel
to the sides using the screw already installed at the top of
side panels and the panel brackets included in the fasteners
package.
3. Tighten side panels to the stove using a long handle screw
driver. See Figure 15B.
Panel brackets
Do not tighten sides until
top is locked into place
Figure 15A
Back view of top
and side panel
assembled
Figure 13B
January 30, 2004
5100-I WOOD INSERT
PANEL and TRIM SET INSTALLATION
Size: 30-1/2" h x 47"w
250-1960 Rev B
LARGE
Size: 34-1/4" h x 51-1/4"w
831-1461, Gold Trim
SP-51l-NL, Nickel Trim
Assembling Trim
1. Place protective covering on surface to be used to assemble
the trim pieces. Lay the trim face down.
2. Attach the 2 side trim pieces to the top trim at each corner
using the "L" bracket included in fasteners package. Slide
assembled trim over panel set. See Figure 15C.
View of "L" Bracket
installed
Figure 15C
R
Page 15