Connection - Kenwood DNX7280BT Quick Start Manual

Quick Start Guide

Connection

Connecting wires to terminals (1)
Accessory 9
8 6 4
7 5 3
8 6 4
7 5 3
A: Black
(Ground wire)
*DNX7280BT only
B: Yellow
(Battery wire)
C: Red
(Ignition wire)
FM/AM antenna input
Accessory 9:
Bluetooth Microphone
Accessory 7
Cooling fan
Accessory 1
C B A
2
1
2
1
ILLUMI
Orange
Orange/White
/White
(Dimmer control wire)
Accessory 9
Fuse
(15A)
2 WARNING for Connecting the ISO Conncetor
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive. Make
sure to make the proper connections to prevent
damage to the unit. The default connection for the
wiring harness is described in (1) below. If the ISO
connector pins are set as described in (2), make the
connection as illustrated. Please be sure to reconnect
the cable as shown (2) below to install this unit to
the Volkswagen vehicles etc.
(1): Default setting
The red (A-7 pin) of the vehicle's ISO connector is
linked with the ignition, and the yellow (A-4 pin) is
connected to the constant power supply.
Red (Ignition cable)
Unit
Yellow (Battery cable)
(2)
The red (A-7 pin) of the vehicle's ISO connector is
connected to the constant power supply, and the
yellow (A-4 pin) is linked to the ignition.
Red (Ignition cable)
Unit
Yellow (Battery cable)
Accessory 7: GPS Antenna
28
Accessory 7
Fuse
Cooling fan
(15A)
Red (A-7 pin)
Vehicle
Yellow (A-4 pin)
Red (A-7 pin)
Vehicle
Yellow (A-4 pin)