Light Sensor; Precautions - Honeywell PCR426W User Manual

Weather forecaster with dual projection

Hide thumbs Also See for PCR426W:

Table of Contents

Enlarged version

NOTE: The Weather Forecaster projects only Channel 1 (one) remote

temperature

· Press FLIP button to rotate projected image 180° c lockwise

· Press and hold FLIP button for 2 seconds to change temperature

information from remote to indoor

· Press and hold FLIP button for 2 seconds again and the

projected image will alternate between the remote and indoor

temperature every 5 seconds.

NOTE: During initial product setup (remote sensor and at omic time

signal search) there will be no remote temperature projected.

CONTINUOUS TIME AND TEMPERATURE PROJECTION

· Connect AC/DC adapter provided with the product to project the

time and temperature image continuously.

· Slide the CONTINUE PROJECTION switch to the arrow direction

shown on the main unit s side: the current time and temperature

will be projected on the wall or the ceiling.

LIGHT SENSOR

The Weather Forecaster is equipped with the light sensor which detects

the environmental light conditions. At the light conditions lower than 100

LUX, the LCD will light up automatic ally if AC adapter is connected. The

backlight can be set using the LIGHT SENSOR switch modes:

AUTO automatic LCD backlight

ON continuous LCD backlight

OFF-- turns off LCD backlight

This product is engineered to give you years of satisfactory service if

handled carefully. Here are a few precautions:

· Do not immerse the unit in water.

· Do not clean the unit with abrasive or corrosive materials. They

Table of Contents