Hp E8491A Triggering; Using Triggers - HP AHA-8940 Configuration And User's Manual

HP E8491A
Triggering
Trigger Lines
TTLTRG7 - TTLTRG0
(VXI backplane)
ECLTRG1 - ECLTRG0
(VXI backplane)
Trig In Port*
(HP E8491A faceplate)
Trig Out Port*
(HP E8491A faceplate)
* The E8491A Trig In and Trig Out ports are configured using the HP I_O Libraries 'I_O Config'
utility.

Using Triggers

Chapter 3
The HP E8491A is capable of asserting, receiving, and routing trigger
signals along the VXI (mainframe) backplane trigger lines. In addition to the
VXI backplane's eight TTL level trigger lines and two ECL level trigger
lines, the E8491A can receive and assert triggers on the faceplate 'Trig In'
and 'Trig Out' connectors.
Table 3-1 summarizes the triggering parameters and capabilities of the
HP E8491A.
Table 3-1. HP E8491A Triggering Parameters.
Trigger Levels
Trigger levels or pulses can be
output on any number of
TTLTRG trigger lines.
Trigger levels or pulses can be
output on any number of
ECLTRG trigger lines.
Input trigger levels are TTL, ECL,
CMOS, or programmable up to
+30V. Default assumes TTL low
true signal.
Output trigger level is +5V (low
true - default) and can be pulled
to +30V.
The triggering functionality of the HP E8491A is accessed through the
following HP VISA and SICL functions:
Asserting Triggers - HP VISA
viSetAttribute
VI_ATTR_TRIG_ID
VI_TRIG_TTL0 to VI_TRIG_TTL7
VI_TRIG_ECL0 to VI_TRIG_ECL1
viAssertTrigger
VI_TRIG_PROT_DEFAULT
VXI Programming Using the IEEE 1394 Serial Bus
Trigger Routing
One TTLTRG trigger line can be
routed to one ECLTRG trigger line.
One ECLTRG trigger line can be
routed to one TTLTRG trigger line.
Input triggers can be routed to any
number of TTLTRG trigger lines and
to any number of ECLTRG trigger
lines.
One TTLTRG or ECLTRG trigger line
can be routed to the Trig Out port
43