Installing A- And B-Size Instruments - HP AHA-8940 Configuration And User's Manual

WARNING
Installing A- and B-size
Instruments
22 Interface Installation and Configuration
All instruments within the VXI mainframe are grounded through
the mainframe chassis. During installation, tighten the
instruments' retaining screws to secure the instrument to the
mainframe and to make the ground connection.
A- and B-size instruments can also be installed in the mainframe. These
instruments are installed using a module carrier:
•
HP E1403C A/B-size Module Carrier extends the P1 connector on
the VXIbus backplane and mounts the (A/B-size) modules flush with
C-size modules. This carrier is recommended for Hewlett-Packard
B-size, slave-only devices which have the P1 connector.
•
HP E1407A A/B Module Carrier extends the P1and P2 connectors
on the VXIbus backplane. This carrier is recommended for B-size,
slave-only devices which have the P1/P2 connectors.
Figure 2-9 shows the installation of A- and B-size instruments.
Chapter 2