HP Kayak XU800 Technical Reference Manual page 100

5 HP BIOS
Adaptec SCSISelect Configuration Utility
Options
Extended BIOS Translation for DOS
drives > 1 GByte
Verbose/Silent Mode
Host Adapter BIOS
Support for Removable Disks Under
BIOS as Fixed Disks
Display <F6> message during
BIOS Initialization
BIOS Support for Bootable CD-ROM
BIOS Support for Int 13h Extensions
Domain Validation
SCSI Device Options
SyncTransfer Rate
Enable Disconnection
Initiate Wide Negotiation
(16-bit adapters only)
Send Start unit Command
Enable Write Back Cache
BIOS Multiple Lun Support
Include in BIOS Scan
100
Advanced Configuration Options
Default Comments
Settings
Enabled Includes an extended translation scheme that supports
disk drives of more than 1 GByte.
Verbose Displays messages on the screen at POST.
Enabled Controls the state of the BIOS at POST.
Disabled No removable media drives running under DOS are
treated as hard disk drives. Driver software is required
because the drives are not controlled by the BIOS.
Enabled Displays
Press F6 for SCSISelect(TM)
Utility!
Enabled Enables booting from a CD-ROM.
Enabled Host adapter BIOS supports Int 13h extensions.
Disabled Downgrades the performance while maintaining the
integrity of data transmission
SCSI Device Configuration Options
Default Comments
Settings
160 Determines the synchronous data transfer rate that
the host adapter will negotiate with the device.
Yes Determines whether the host adapter allows a SCSI
device to disconnect from the SCSI bus (also referred
to as Disconnect/Reconnect).
Yes Allows the adapter to initiate wide negotiation with a
16-bit SCSI device.
Yes Determines whether the host adapter sends the Start
Unit command to the SCSI bus.
N/C Allows the BIOS to program the state of the write
back cache in the hard disk drive.
No Allows the BIOS to support multiple logical units.
Yes Determines whether the host adapter BIOS supports
devices attached to the SCSI bus without the need for
device driver software.