Extron electronics HSA 200S User Manual page 29

Packaging for Shipment
The HSA 200's and HSA 222's ultra-fine machined surfaces and
moving parts make them vulnerable to damage caused by
mishandling during shipment, if they are improperly packaged.
If, for any reason, you need to return an HSA to Extron, first
contact Extron to obtain a return kit. The return kit, which
reduces the chances of damage during shipment, includes a
sturdy shipping carton and foam shells custom cut to fit the
HSA (figure B-1).
Figure B-1 — HSA 200/HSA 222 return kit
Package an HSA for shipment as follows:
1. Contact the Extron S
obtain a return kit. Extron will send the return kit to the
location you specify.
The flanged edges of the top of the surface
enclosure are sharp when the HSA is removed from
the table. Exercise caution when handling to
prevent personal injury.
The flanged edges of the top of the surface
CAUTION
enclosure are bevelled to an ultra-fine thickness of
less than 0.04 (4/100)" (approximately 1 mm).
These edges are soft and can be easily nicked or
bent. Exercise caution when handling and
mounting the enclosure. Mishandling can damage
the appearance of the enclosure.
HSA 200/222 Series • Packaging for Shipment
B-2
3
Sales & Technical Support Hotline to
2. Disconnect all cables and remove the HSA 200 or HSA 222
from the table or desk. See "Removing and Replacing the
Enclosure", steps 1 through 4, in chapter 3, "Maintenance
and Modifications".
3. Place the enclosure on a flat, horizontal surface. To protect
the finish, place it on a soft cloth or rubber mat.
4. Install the plastic strip (part of the return kit) to protect the
flanged edges of the top of the enclosure (figure B-2).
Figure B-2 — Installing protective strips
Open the top panel and insert the HSA 200 or HSA 222
5.
into the custom cutout portion of one of the foam shells
(figure B-3).
Figure B-3 — Installing the HSA into the foam
shell
HSA 200/222 Series • Packaging for Shipment B-3