Pride Mobility Pride LX10 Owner's Manual page 36

X . C A R E
Cleaning Precautions
CAUTION! Never hose off your Pride LX or place it in direct contact with water. Your LX has a
painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.
CAUTION! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
CAUTION! Direct exposure to water or dampness could cause the power chair to malfunction
electronically and mechanically. Water can cause electrical components to corrode and the
chair’s frame to rust.
Should your power chair come in contact with water:
1. Dry your power chair as thoroughly as possible with a dry towel.
2. Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your power chair again.
4. If you find any inconsistencies, take your power chair to an authorized Pride provider.
Temperature
Some of the parts of your power chair are susceptible to extreme changes in temperature. Always keep your power
chair between the temperatures of 18° F and 122° F.
n In extremely cold temperatures, the batteries may freeze. The specific temperature at which they freeze depends
on a number of factors, such as battery charge, usage, and composition of the batteries (e.g., sealed lead-acid or
gel cell).
n Temperatures above 122° F may cause your power chair to operate at a reduced speed. This reduced speed is a
safety feature built into the controller that helps prevent damage to the motor and other electrical components.
See IX. “Operation.”
Tires
You should check your tires at least once per week. This will
prolong the life of your tires as well as help ensure the perfect
operation of your chair. Look for cuts in your tires or uneven
wear. If you have solid tires, you must replace the whole wheel.
If you have pneumatic tires, you can replace the tire or the tube.
Replacement parts are readily available at your authorized Pride
provider.
WARNING! To avoid possible injury, be sure that the
controller’s power is turned off and the power chair
is not in freewheel mode before performing this
procedure.
WARNING! Completely deflate the tire before
attempting repair.
36
A N D M A I N T E N A N C E
www.pridemobility.com
17-MM DRIVE WHEEL NUT AND WASHER
Figure 30. Drive Wheel and Motor Brush Location
Pride LX Series/Rev B/Feb 03
MOTOR BRUSH
CAP