Pilot Controller - Pride Mobility Pride LX10 Owner's Manual

PILOT CONTROLLER

The electronic controller is what you use to operate your power chair. It takes the battery voltage and sends it to the
appropriate system. The electronic controller also enables you to monitor battery charge, electronic controller
functions, and the condition of your electrical system. Also, it may be used to control some optional systems such
as power elevating seats and lights.
The Pilot electronic controller is an integral electronic controller. All of the electronics necessary to operate the
power chair are contained in one module. See
figure 29.
The Pilot consists of:
1. joystick
2. on/off button
3. battery condition meter
4. speed control knob
5. off-board charger/programming socket
6. controller connector
7. 3-pin charger inhibit connector
Typically, the Pilot is mounted to one of the
armrests and is connected to the motors, batteries,
and the onboard charger at the electronics tray.
Joystick
The joystick controls the direction and speed of
your power chair. When you move the joystick from the neutral (center) position, the electromagnetic brakes
release and allow your power chair to move. The further you push the joystick from its neutral position, the faster
your power chair moves. When you release the joystick and allow it to return to the netural position, you engage
the electromagnetic brakes. This causes your power chair to decelerate and come to a complete stop.
WARNING! If your power chair begins to move in an unexpected manner, immediately release the
joystick. Unless the joystick is damaged, this action should stop your power chair.
On/Off Button
This is a green button located in front of the joystick. It turns the Pilot on and off.
WARNING! Unless faced with an emergency situation, do not use the on/off push button to stop
the chair. This will cause the power chair to stop abruptly.
WARNING! Always turn the power off when you are stationary to prevent unexpected movement.
Battery Condition Meter
The battery condition meter is located in front of the joystick. This is a 10-segment illuminated display that indicates
that the Pilot is turned on and also gives the battery status, the Pilot status, and the electrical system status.
n Red, yellow, and green lights lit: Battery charged; Pilot and electrical system OK.
Pride LX Series/Rev B/Feb 03
I X . O P E R A T I O N
Figure 29. The Pilot Controller
4
7
www.pridemobility.com
1
2
6
5
3
31