Pride Mobility Pride LX10 Owner's Manual page 17

I V . U N P A C K I N G
13. Connect the controller to the motors. The motor/controller connectors are marked “L” for left and “R”
for right. Match the “L” on the controller with the “L” on the motor. Match the “R” on the controller
with the “R” on the motor. Connect the black connector to the controller connector. See figure 15.
CAUTION! Do not place the controller cable so that it can be pinched in the seat frame or the
power base frame.
14. Install the footrests. See figure 11.
15. Install the anti-tip wheels. See figure 12.
16. Remove the battery charger from the box and plug into charger port. Follow the charging instructions printed
on the charger. See figure 13.
17. Read the owner's manual thoroughly before operating your power chair.
INSTALL JOYSTICK/CONTROLLER
INTO ARMREST AND TIGHTEN KNOB.
Figure 10. Joystick/Controller Installation
SQUEEZE BUTTONS
TO INSTALL ANTI-TIP.
Figure 12. Anti-tip Installation
Pride LX Series/Rev B/Feb 03
A N D A S S E M B L Y
Figure 11. Footrest Installation
BATTERY CHARGER
Figure 13. Charging the Batteries
www.pridemobility.com
17