Table of Contents
Advertisement
Troubleshooting guide
The unit does not work.
I cannot remove the tape from
the unit.
- Plug in the AC adaptor again.
The answering system is on but
no incoming messages are
recorded.
-The greeting message is
recorded improperly or not
recorded, so no one can leave
a message. Check and record a
new greeting message.
- lf the call counter shows "AO",
the REC TIME selector is set to
the GREETING ONLY position.
Change it to the VOX or 1 MIN
position.
-The incoming message taPe is
full. Reset it or rePlace with a
new one.
The call counter shows
"E".
- The greeting message cassette
tape might be broken. RePlace
it with a new one.
6 quick beeps sound during
greeting message recording,
and it results in failure.
- Re-record Your greeting
message. SPeak clearlY and
loudly, and do not Pause for
over 5 seconds while recording.
When a message is PlaYed
back, the sound level is low,
even if the VOLUME is high.
- Clean the heads.
(See page 37.)
- Replace the incoming message
tape with a new one.
The unit does not answer
remotely.
-The answering system is turned
off. (The unit is not in the
answer mode.) To set the unit
to answer the call, call your unit
and wait for
'15 rings.
(See page 32.)
I press the dial button of a
touch tone phone after mY unit
answers, but the answering
system does not resPond.
- Make sure that you Press Your
correct remote code number.
To check your remote code
number, see page 27.
- The answering system may not
respond if a remote touch tone
phone produces tones that are
too short to activate the unit, so
when you press any button,
press firmly.
rt+
(Continued on next page---+)
- 3 5 -
Advertisement
Table of Contents
