Table of Contents
Advertisement
Elite 23 Product Manual, Rev. A
2.0
Applicable standards and reference documentation
The drive is a system peripheral developed to the highest standards of design and construction. The drive
depends on its host equipment to provide adequate power and environment to achieve optimum performance
and compliance with applicable industry and government regulations. Special attention must be given in the
areas of safety, power distribution, shielding, audible noise control, and temperature regulation. Also, the drive
must be securely mounted to guarantee the specified performance characteristics.
2.1
Standards
The Elite 23 family complies with Seagate standards as noted in the appropriate sections of this manual and
the Seagate SCSI Interface Product Manual (volume 2), part number 77738479.
The Elite 23 disc drive is a UL recognized component per UL1950, CSA certified to CSA C22.2 No. 950-M89,
and VDE certified to VDE 0805 and EN60950.
2.1.1
Electromagnetic compatibility
The drive, as delivered, is designed for system integration and installation into a suitable enclosure prior to use.
As such, the drive is supplied as a subassembly and is not subject to Subpart B of Part 15 of the FCC Rules
and Regulations nor the Radio Interference Regulations of the Canadian Department of Communications.
The physical design characteristics of the drive serve to minimize radiation when installed in an enclosure that
provides reasonable shielding. As such, the drive is capable of meeting the Class B limits of the FCC Rules
and Regulations of the Canadian Department of Communications when properly packaged. However, it is the
user's responsibility to assure that the drive meets the appropriate EMI requirements in their system. Shielded
I/O cables may be required if the enclosure does not provide adequate shielding. If the I/O cables are external
to the enclosure, shielded cables should be used, with the shields grounded both to the enclosure and to the
host controller.
2.1.1.1
Electromagnetic susceptibility
As a component assembly, the drive is not required to meet any susceptibility performance requirements. It is
the responsibility of those integrating the drive within their systems to perform those tests required and design
their system to ensure that equipment operating in the same system as the drive or external to the system
does not adversely affect the performance of the drive. See Section 5.1.1 and Table 2, DC power requirements.
2.2
Electromagnetic compliance
Seagate uses an independent laboratory to confirm compliance to the directives/standard(s) for CE Marking
and C-Tick Marking. The drive was tested in a representative system for typical applications. The selected sys-
tem represents the most popular characteristics for test platforms. The system configurations include:
• 486, Pentium, and PowerPC microprocessors
• 3.5-inch floppy disc drive
• Keyboard
• Monitor/display
• Printer
• External modem
• Mouse
Although the test system with this Seagate model complies to the directives/standard(s), we cannot guarantee
that all systems will comply. The computer manufacturer or system integrator shall confirm EMC compliance
and provide CE Marking and C-Tick Marking for their product.
Electromagnetic compliance for the European Union
If this model has the CE Marking it complies with the European Union requirements of the Electromagnetic
Compatibility Directive 89/336/EEC of 03 May 1989 as amended by Directive 92/31/EEC of 28 April 1992 and
Directive 93/68/EEC of 22 July 1993.
3
Advertisement
Table of Contents
