Maintenance (Mixer) - MULTIQUIP Whiteman WM70SH8C Operation And Parts Manual

druM Head SealS
There is 1 set of drum head seals (Figure 24) that will
require lubrication. Lubricate the grease fitting for each
drum seal every 40 hours of operation using any grade
lithium base grease. Apply grease until visible inside of
mixing drum (over grease). This will purge seal system of
contamination.
GREASE FITTING
AND CAP
Figure 24. Grease Fittings (Drum Head Seals)
druM Bearing BraCkeT luBriCaTion
There is 1 set of drum bearing brackets (Figure 25) that
will require lubrication. These brackets are intended to
make the drum rotate freely. Lubricate the grease fitting
for each drum bearing bracket every month or when the
drum becomes difficult to position using multi-purpose
grade grease.
page 26 — WM70SH5C/WM70SH8C Mixer • operaTion and parTS Manual — rev. #0 (06/07/11)
DRUM HEAD
SEALS
GREASE FITTING
AND CAP

MaintenanCe (Mixer)

GREASE FITTING
AND CAP
DRUM BEARING
BRACKET
Figure 25. Grease Fittings (Dumping
Mechanism)
CauTion
Failure to lubricate the drum bearing grease fittings
periodically will cause the dumping mechanism to
stiffen, making the mixing drum hard to dump.
Ball SoCkeT and ClaMp FaCe MainTenanCe
1. If the towing vechicle is equipped with a ball socket,
smear socket periodically with multi-purpose grease.
This will keep the ball socket well lubricated.
2. Periodically oil pivot points and clamp face surfaces of
coupler with SAE 30 WT. motor oil.
3. When parking or storing your mixer. Keep the coupler
off the ground so dirt will not build up in the ball socket.
CounTerSHaFT Bearing luBriCaTion
There is 1 set of countershaft bearings (Figure 26) that
will require lubrication. Lubricate the grease fitting for each
countershaft bearing every 40 hours of operation using any
grade lithium base grease.
GREASE FITTING
AND CAP