Inspection - MULTIQUIP Whiteman WM70SH8C Operation And Parts Manual

BeFore STarTing
1. Read all safety instructions at the beginning of manual.
2. Clean the unit, removing dirt and dust, particularly the
engine cooling air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty,
replace air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with
dry compressed air.
5. Check fastening nuts and bolts for tightness.
CauTion
alWaYS wear approved eye and hearing
protection while operating the mixer.
CauTion
never place hands or feet inside the
engine guard cover while the engine is
running. alWaYS shut the engine down
before performing any kind of maintenance
service on the mixer.
engine oil CHeCk
1. To check the engine oil level, place the unit on secure
level ground with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 5) and wipe it clean.
Figure 5. Engine Oil Dipstick (Removal)
page 16 — WM70SH5C/WM70SH8C Mixer • operaTion and parTS Manual — rev. #0 (06/07/11)
3. Insert and remove the dipstick without screwing it into
the filler neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 6), fill to the edge of the
oil filler hole with the recommended oil type (Table 5).
Maximum oil capacity is 2.33 pints (1.09 liters).
NOTICE
Reference engine manufacturer's manual for specific
servicing instructions.
Figure 6. Engine Oil Dipstick (Oil Level)
Table 5. oil Type
Season Temperature
Summer 25°C or Higher
Spring/Fall 25°C ~ 10°C
Winter 0°C or Lower

inspeCtiOn

UPPER LIMIT
LOWER LIMIT
oil Type
SAE 10W-30
SAE 10W-30/20
SAE 10W-10