Operating The Appliance; Filling The Water Tank; Heater Switch - Morphy Richards Essentials Compact Steam Cleaner User Manual

VC70455MUK Rev6_Instruction Booklet 13/08/2012 14:40 Page 4
A
B
C
UK Helpline 0844 871 0960
4
OPERATING THE
APPLIANCE
Please remember that the steam
cleaner operates by emitting
steam at an increased
o
temperature of 115 C. Never
use on materials or surfaces
that cannot resist this
temperature, such as dralon,
plastic, natural fur etc.
Where any doubt exists, check
carefully on a part of the
material where minor marks will
not matter.

Filling the water tank

To fill, unscrew the filler cap ‹
1
anti-clockwise A.
2 Fill the boiler with a maximum of
1 litre of water by using the
funnel and the filler jug provided
B.
Three full jugs equal the
maximum 1 litre.
Use warm water or less water to
reduce the heat up time.
One jug will provide 10 minutes
of steam. The full three jugs will
provide 30 minutes of steam.
WARNING: Do not overfill.
• Do not use any detergent.
3 WARNING: Screw the filler
cap clockwise to tighten.
Tighten fully.

Heater switch

1 When the water tank has been
filled, insert the plug into the
power socket.
2 Fit the required nozzle or
accessory.
3 Switch the cleaner on by
pressing the heater switch ⁄ to
the ON position C.
The boiler will take
approximately 3 minutes to heat
up.
Replacement Parts 0844 873 0726
WARNING: As soon as the
boiler is up to temperature,
steam will begin to be emitted
from the nozzle. Hold the
nozzle away from the body
and away from other persons.
• Water may be ejected at first.
Aim the nozzle into a sink or
bucket.
WARNING: Do not block the
end of the nozzle. If the nozzle
becomes blocked, a safety
relief valve releases steam
pressure from the base of the
filler cap.
NOTE: the 'heater ON' light will
cycle on and off during use, this
is normal.
NOTE: If the product is switched
off before the boiler is empty,
steam will continue to be
emitted for up to 2 minutes. You
can continue to use the steam
to clean or rest the hose in a
sink until the steam has
dispersed.
Refilling
When the steam flow begins to
slow, the unit is ready for
refilling.
1 Switch off the cleaner before
refilling.
2 Unplug from the mains socket
and leave for a few minutes to
cool.
WARNING: Allow any steam to
disperse away from the nozzle
before attempting to remove
the filler cap.
Carefully unscrew the cap A.
3
WARNING: Take care as the
inner part of the cap will be
hot.
4 Use warm water to reduce
heat-up time.
Refill using the funnel and the
jug B.
• The water tank should be
emptied after use. Allow to cool
completely before emptying.
Ireland Helpline 1800 409 119