Directed Electronics AutoCommand 20095 Owner's Manual page 50

➤ The ignition controlled door lock feature o o n n or off: When this
feature is programmed on, the doors will lock three seconds
after the ignition is turned on, and unlock when the ignition
is turned off. If your installer is programming the security
system with the Directed Bitwriter, ignition lock and unlock
are independent features that can be programmed separately.
➤ Passive door locking (with passive arming) or a a c c t t i i v v e e d d o o o o r r
l l o o c c k k i i n n g g (only when arming with the remote). Passive locking
allows the vehicle's doors to lock when the security system
passively arms (after the 30-second countdown). This
feature only works if passive arming has been programmed.
➤ Panic mode e e n n a a b b l l e e d d /disabled when the ignition is turned on.
(Some states have laws against sirens sounding in moving
cars.)
➤ Forced passive arming o o n n or off. If your security system is
programmed for passive arming and the forced passive
arming feature has been programmed on, the system will
passively arm after one hour, even if a protected entry has
been left open. Forced passive arming ensures that the
system will be armed if a door has accidentally been left ajar
when leaving the vehicle.
note: When the system passively arms after one hour, the
entry point that has been left open, and anything con-
nected to the same zone, is bypassed and cannot trigger
the system. However, the remaining inputs to the system
are fully operational.
© 2005 directed electronics—all rights reser ved
47