Directed Electronics AutoCommand 20095 Owner's Manual page 49

p p o o w w e e r r s s a a v v e e r r m m o o d d e e
Your system will automatically enter Power Saver Mode while
armed or in Valet Mode, after a period of time in which no oper-
ation has been performed. This lowers the current draw on the
vehicle's battery. Power Saver Mode takes over under the
following conditions:
➤
Power Saver when the system is armed: After the system has
been armed for 24 hours the LED will flash at half its normal
rate, decreasing the system's current draw.
➤
Power Saver in Valet Mode: When the system enters Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one hour period while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.
p p r r o o g g r r a a m m m m i i n n g g o o p p t t i i o o n n s s
Programming options control your system's normal, operational
set-up. Most options do not require additional parts, but some
may require installation labor.
The following is a list of the programmable options, with the
factory settings in Bold.
➤ A A c c t t i i v v e e arming (from remote only) or passive arming (auto-
matic arming 30 seconds after the last door has been closed).
➤ Arming/disarming siren chirps o o n n or off.
46
© 2005 directed electronics—all rights reser ved