HP MINI 5103 Maintenance And Service Manual page 62

5. If your device has WWAN capability, remove the SIM (see
6. Remove the following components:
a. Keyboard (see
b. Hard drive or solid state drive (see
Remove the WLAN module:
1. Pull back the Mylar shield (1) from WLAN module.
2. Disconnect the wireless antenna cables (2) from the terminals on the WLAN module.
3. Remove the 2 Phillips PM2.0×3.0 screws (3) that secure the WLAN module to the system board.
(The module tilts up.)
4. Remove the WLAN module (4) by pulling the module away from the slot at an angle.
NOTE:
WLAN module slot.
Reverse this procedure to install the WLAN module.
54 Chapter 4 Removal and replacement procedures
Keyboard on page
WLAN modules are designed with a notch (5) to prevent incorrect insertion into the
SIM on page
43)
Mass storage devices on page
39).
50)