4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Memory/WLAN module compartment cover (see
c.
Optical drive (see
d.
Keyboard (see
e.
Switch cover (see
f.
Display assembly (see
g.
Top cover (see
Remove the Media Card Reader/USB connector board:
1.
Disconnect the Media Card Reader/USB connector board cable (1) from the system board.
2.
Remove the two Phillips PM2.5×5.0 screws (2) that secure the Media Card Reader/USB connector
board to the computer.
3.
Lift the Media Card Reader/USB connector board (3) straight up and remove it.
Reverse this procedure to install the Media Card Reader/USB connector board.
Battery on page
46).
Hard drive on page
50)
Optical drive on page
Keyboard on page
62)
Switch cover on page
Display assembly on page
Top cover on page
79)
Expansion memory module on page
60)
68)
75)
Component replacement procedures
54)
85