Machine Settings - Zanussi ZDC 47209W User Manual

Dryer not connected to mains supply.
Dryer does not
work. Loading door opened.
The START PAUSE button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactory
Max. loading exceeded.
drying results.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
Filters not locked in place.
does not close
Err (Error) on
Attempt to change parameters after start of
5)
the programme.
the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis of:
elapsing time
type, volume and dampness of laundry.
5)
on the LCD
Programme in-
Full water reservoir.
active
Drying cycle to Small laundry volume./Too dry laundry for
short selected programme.
Fluff filters clogged.
To high loading volume.
Drying cycle to
Laundry insufficiently spun.
6)
long
Particularly high room temperature - no ma-
chine fault.
1) In case of error message on the LCD (e.g. E51- only dryers with the LCD): Switch the dryer off and on. Set
programme. Press the START PAUSE button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaningchapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).

Machine settings

Setting
www.zanussi.com
Plug in at mains socket. Check fuse in fuse
box (domestic installation).
Close loading door
Press the START PAUSE button.
Set suitable programme.
3)
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter into
place.
Turn the dryer off and on. Set requested pa-
rameters.
Turn it to DRUM LIGHT (if available) or to
any programme.
Replace light bulb (see next section).
Automatic process; this is not a machine
fault.
Empty water reservoir
PAUSE button.
Select time programme or higher drying level
(e.g. EXTRA DRY ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
Implementation
2)
3)
4)
.
3)
, press START
13