Control Panel; Door Reversal - Zanussi ZDC 47209W User Manual

Tumble dryer
Table of Contents

Advertisement

Upon completion there must be no cut, or stray
strands of wire present and the cord clamp
must be secure over the outer sheath.
Warning! A cut off plug inserted into a
13 amp socket is a serious safety
(shock) hazard.
Ensure that the cut off plug is disposed of
safely.
Warning! The plug must be accessible
after installing the machine.
Permanent connection
In the case of permanent connection it is neces-
sary that you install a double pole switch be-
tween the appliance and the electricity supply
(mains), with a minimum gap of 3 mm between
the switch contacts and of a type suitable for
the required load in compliance with the current
electrical regulations.
The switch must not break the yellow and green
earth cable at any point.

Door reversal

To make it easier to load or unload the laundry,
the door can be reversed.
Warning! The door must only be reversed
by an authorised service engineer.
Please contact your local Service Force Centre.
The engineer will carry out the door reversal at
your cost.
Special accessories
• stack kit
1
2
3
4
5
6
Available from your Service Force Centre
or your specialist dealer
These intermediate installation kits can be
used to arrange the dryer and an washing
machine (60 cm wide, front loaded) as a
space-saving washer/dryer stack. The wash-
ing machine is at the bottom and the dryer is
at the top.
Read carefully the instructions supplied with the
kit.
• drain kit
Available from your Service Force Centre
or your specialist dealer
Installation kit for direct draining of conden-
sate into a basin, siphon, gully, etc. The con-
densate tank then no longer has to be
drained, it must however remain in its inten-
ded position in the machine.
Read carefully the instructions supplied with the
kit.
• pedestal with the drawer
Available from your Service Force Centre
or your specialist dealer
To situate the dryer in optimal high and have
some additional space to store (e.g. laundry).
Read carefully the instructions supplied with the
kit.
Worktop
1
Rating Plate
2
6
Heat exchanger
3
7
Water reservoir
4
Heat exchanger door
5

Control panel

6
8
Fluff filters
7
Loading door
8
9
Ventilation grille
9
10
Adjustable feet
10
www.zanussi.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents