Trouble Shooting - Westinghouse WFM1810WC User Manual

tRoUbLE SHootING

pRobLEM
Appliance does not work
Appliance cools too much .
The food is too warm .
Heavy build-up of
frost, possibly also on
the door seal .
Unusual noises .
The compressor does
not start immediately
after changing the
temperature setting .
Water on the floor or
storage shelves .
poSSIbLE cAUSE
Appliance is not switched on .
Mains plug is not plugged in or is loose .
Household fuse has blown or is defective .
Socket is defective .
Temperature is set too cold .
Temperature is not properly adjusted .
Door was open for an extended period .
A large quantity of warm food was placed in the
appliance within the last 24 hours .
The appliance is near a heat source .
Door seal is not air-tight (possibly after reversing
the door) .
Appliance is not level .
The appliance is touching the wall or
other objects .
A component, e .g . a pipe, on the rear of the
appliance is touching another part of the
appliance or the wall .
This is normal, no error has occurred .
Water drain hole is blocked .
SoLUtIoN
Switch on the appliance .
Insert mains plug .
Check fuse, replace if necessary .
Mains malfunctions are to be corrected by
an electrician .
Turn the temperature regulator to
a warmer setting temporarily .
Please look in the initial "Start Up" section.
open the door only as long as necessary.
Turn the temperature regulation to a colder
setting temporarily .
Please look in the "installation location" section.
Carefully warm the leaking sections of the door
seal with a hair dryer (on a cool setting .
At the same time shape the warmed door seal by
hand so that it sits correctly .
Re-adjust the feet .
Move the appliance slightly .
If necessary, carefully bend the component out of
the way .
The compressor starts after a period of time .
See the "cleaning and care" section.
9