Temperature Setting; First Use And Installation - Westinghouse WFM1810WC User Manual

StARtING Up ANd tEMpERAtURE REGULAtIoN
Mid
Less Cold Colder
Temperature selector knob that controls the temperature
inside the freezer compartment is located on the top of
the refrigerator
• Position Less Cold.
• Position Mid.
• Position Colder.
Starting up and temperature regulation
Insert the plug of the connection lead into the plug socket
with protective earth contact .
Setting Less Cold means:
Highest temperature, warmest setting .
Setting Colder means:
Lowest temperature, coldest setting .
Important! – Normally we advise you to select the setting
of Mid . If you want the temperature Less Cold or colder
please turn the knob to lower or higher setting accordingly .
Less cold temperature settings are more energy efficient .
Important! – High ambient temperatures (e .g . on hot days)
and a cold setting on the temperature regulator (position
Max) can cause the compressor to run continuously or
even non-stop .
Reason: when the ambient temperature is high, the
compressor must run continuously to maintain the low
temperature in the freeze .
6

fIRSt USE ANd INStALLAtIoN

Cleaning before use
• B efore using the appliance for the first time, wash
the interior and all internal accessories with lukewarm
water and some neutral soap, then dry thoroughly .
Important! Do not use detergents or abrasive powders,
as these will damage the finish .
Installation Positioning
WARNING
Before installing, read the instruction carefully for your safety
and correct operation of the appliance .
• P osition the appliance away from sources of heat such
as stoves, radiators, direct sunlight etc .
• M aximum performance and safety are guaranteed by
maintaining the correct indoor temperature for the class
of unit concerned, as specified on the rating plate .
• T his application performs well from N to ST (see table
below) . The Appliance may not work properly if it is left
for a longer period at a temperature above or below
the indicated range .
Important! Adequate ventilation around the freezer is
needed for easy dissipation of heat, high efficiency of
refrigeration and low power consumption . For this purpose,
sufficient clear space should be available around the
fridge . It is advisable for there to be 75mm separating the
back of the fridge to the wall, at least 100mm of space
at its two sides, height of over 100mm from its top and a
clear space upfront to allow the doors to open 160° .
cLIMAtE cLASS
SN
N
ST
T
• A ppliances must not be exposed to rain. Sufficient air
must be allowed to circulate in the lower rear section
of appliances, as poor air circulation can affect
performance . Built-in appliances should be positioned
away from heat sources such as heaters and
direct sunlight .
Levelling
• T he appliance should be level in order to eliminate
vibration . To make the appliance level, it should be
upright and both adjusters should be in firm contact
with the floor . You can also adjust the level by screwing
up or down the appropriate level adjuster at the front of
the appliance (use your fingers or a suitable spanner) .
AMbIENt tEMpERAtURE
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C