Maintenance And Troubleshooting - NordicTrack NTEVEX79913.0 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If lines appear in the console display, see HOW TO
CHANGE CONSOLE SETTINGS on page 27 and
adjust the contrast level of the display.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 20.
If the console does not display your heart rate
when you use the chest heart rate monitor, see
TROUBLESHOOTING on page 15.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first unplug the power
adapter (not shown). Using a flat screwdriver, gently
release the tabs on the Front Shield Cover (8) and lift
the Front Shield Cover off the exercise bike.
Locate the Reed Switch (57). Turn the Pulley (38) until
a Magnet (55) is aligned with the Reed Switch. Next,
loosen, but do not remove, the indicated M4.2 x 18mm
Screw (78). Slide the Reed Switch slightly closer to or
away from the Magnet, and then retighten the Screw.
Plug in the power adapter, and turn the Pulley (38) for
a moment.
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the front shield cover.
30
8
38
55
57
78