Ariens 932048 - ST5520 Owner's/Operator's Manual page 22

Attachment Clutch Lever
(15,2 cm - 17,8 cm)
Figure 25
2. Remove belt cover.
IMPORTANT: The clutch cable must be slack when
clutch lever is disengaged.
3. Adjust cable slack.
a. With the clutch lever disengaged, adjust
lower cable adjuster on the attachment clutch
arm so about 1/16" (2 mm) of thread extends
past the lower mounting nut (Figure 26).
b. With the clutch lever disengaged, adjust
upper cable adjuster on the cable mounting
bracket so about 5/16" (8 mm) of thread
extends past the upper mounting nut
(Figure 26).
c. Tighten the nuts with a wrench.
6 in. - 7 in.
OS2490
About 5/16" (8 mm) of
thread above nut.
7
5
6
5
4
1. Upper Cable Adjuster
2. Right Hand Handlebar
3. Attachment Clutch Arm
4. Attachment Clutch Cable
5. Cable Mounting Nuts
6. Lower Cable Adjuster
7. Cable Mounting Bracket
4. Adjust attachment clutch lever measurement, if
necessary.
a. Loosen attachment idler nut (Figure 22 or
Figure 23).
b. To increase distance between clutch lever
and handlebar, move the idler towards the
attachment belt.
c. To decrease the distance between the clutch
lever and handlebar, move the idler away
from the attachment belt.
d. Tighten idler adjustment nut.
e. Check clutch lever measurement.
GB - 22
1
3
About 1/16"
(2 mm) of thread
below nut.
Figure 26
2
OS7260
OS7255