Engine Removal; Engine Installation - Ariens Sierra 936014-026 Service Manual

5.2 ENGINE REMOVAL

1. Open and remove the hood from the unit.
2. Remove the negative cable from the battery.
3. Remove the attachment from the unit.
4. Remove the PTO clutch from the bottom of the
engine sheave. Remove the main drive belt from
the engine sheave by setting the parking brake.
5. Remove the throttle and choke control from the
engine.
6. Remove the electrical wiring from the engine
(charge lead, oil pressure lead, fuel solenoid lead,
and magneto kill wire).
7. Remove the exhaust system from under the frame.
Separate the muffler from the exhaust pipe that is
bolted to the engine.
8. Remove the engine bolts and lift the engine with a
hoist to remove it from the frame.
Figure 24

5.3 ENGINE INSTALLATION

1. Check the engine base and unit frame for damage
before installing the engine.
2. Place the throttle, choke control, and electrical wire
out of the way prior to placing the engine onto the
unit frame.
3. Once the engine is bolted onto the frame install the
exhaust system and then tighten the mounting
hardware.
4. Install the engine sheave and belts. Connect PTO
clutch, electrical wiring, throttle and choke controls.
5. Prior to installing the attachment check for proper
belt alignment and clutch function.
6. Install the negative battery cable onto the battery.
7. Reinstall the attachment onto the unit.
8. Install and close the unit hood and test operation
and function of the engine.
9336-18
5 - 24
Figure 25
936-19