Table of Contents
Advertisement
INSTALLATION
Unpacking
All transit bolts and packing must be removed before
using the machine.
You are advised to keep all packing for re-use in case
you move house and the machine has to be transpor-
ted again.
Proceed as follows:
P0255
P0234
Remove the polystyrene block from underneath the
machine.
Release the two polythene bags by removing the
adhesive strip.
Carefully remove the right polythene bag (1) by pull-
ing it towards the centre of the machine. Repeat the
operation for the left polythene bag (2).
P0256
Set the machine upright and unscrew the two remai-
ning rear screws.
Slide out the 3 plastic spacers and plug the 3 holes
with the 3 plastic plugs which you can find on the
back of the machine.
4
Using a spanner remove
the screw on the right at
the rear of the machine.
Carefully lay the machine
on its back making sure
that the hoses are not
squashed.
Place one of the polysty-
rene angle packings
between the machine
and bottom.
2
1
P0233
P0020
Positioning
Position the machine on a firm level surface.
The machine must not touch the wall or other furni-
ture.
It is assumed that the tap, drainage point and socket
are within easy reach of the machine hoses and
power supply cable. If not, you are advised to call
your fitter in order to move the tap and/or drainage
point and/or socket.
P0023
Water inlet
P0003
P0021
it completely with a longer high pressure hose specifi-
cally designed to solve problems of this type.
Connect the water inlet
hose to a tap with a
3
gas thread spout after fit-
ting the filter supplied
with the machine.
The other end of the inlet
hose connected to the
machine can be turned in
any direction. Simply loo-
sen the fitting, rotate the
hose and retighten.
The inlet hose must not
be extended. If it is too
short and you do not wish
to move the tap, replace
/
"
4
Hide quick links:
Advertisement
Table of Contents
