Table of Contents
Advertisement
USE
Control panel
1 Detergent dispenser drawer and programme card
P0874
Programme cards in various languages are supplied
with the machine. One of these cards is located on
the front of the dispenser drawer, the others are in the
document pack.
Water cooling switch
P0814
thermometer symbol with a screwdriver.
When a 95° wash programme has been selected,
cold water will be taken into the drum to reduce the
water temperature from 95°C to about 60°C before
the wash water is emptied.
The dispenser drawer must be pulled out to gain
access to this switch. See instructions on page 13.
2 ON/OFF button
Depress this button to start the machine, depress it
again to stop a programme and to swicth off the
machine.
6
1
Symbols
Prewash
Wash
Fabric softener
The appliance has been
factory set for low water
consumption (the cooling
phase is not automatical-
ly set).
It may however be ne-
cessary, in certain cases
(very old drain pipes) to
cool the wash water by
operating this switch.
To do this, turn it to the
2 3 4 5 6
3 «Spin reduction» button
By depressing this button the spin speed is reduced
as follows:
programmes for cotton and linen: from 850 to 650
rpm;
programme "N" (short spinning) from 650 to 550
rpm.
4 «Economy » button E
For normally or lightly soiled laundry you can select
programme B 60°C (cotton & linen) and programme
H 40°C (synthetics) by depressing button E.
The reduction in temperature from 95° to 60° and
from 60° to 40° will save power consumption. Equally
good results will be obtained because the reduced
temperature is compensated by maintaining the full
washing time.
5 «Door open» button
Press this button to open the door.
6 «Door locked» light
This light (red) stays on whilst the door is locked. The
door cannot be opened until the light has gone out.
7 «Temperature selector
With this knob you select the washing temperature.
Turn the knob clockwise or anti-clockwise to the
required position.
It is also possible to perform a cold wash by turning
the knob to the
8 «Programme selector» knob
To select the required programme turn this knob
clockwise.
9 Operating pilot light
This light comes on when the machine starts opera-
ting.
7
8
symbol.
9
Hide quick links:
Advertisement
Table of Contents
