Bradford White POWERED DIRECT VENT SERIES GAS-FIRED COMMERCIAL WATER HEATER Installation & Operation Manual page 44

Step 5: 30 Seconds after the last button press, the Water Heater Display will go back to "User Mode". It will read "Max
Setpoint" without showing a temperature value if the temperature setpoint is at the maximum setting. The Water Heater
Display can be set back to the "User Mode" immediately by pressing both the "Temperature Up" and "Select" buttons
together for 3 seconds.
Display of Water Temperature:
Step 1: In Service Mode, Press the "Select" button until "Water Temp" is displayed in the upper right section of the water
heater display. For water heaters using two temperature sensors in the tank, this will be the average reading
between the two sensors. For water heaters using a single sensor, this is the reading for the sensor.
idle
Status

SELECT
Exiting Service Mode
idle
Status

SELECT

Max
Setpoint
Operational
SET
Water
°F
Temp
Operational
SET
44