Bradford White POWERED DIRECT VENT SERIES GAS-FIRED COMMERCIAL WATER HEATER Installation & Operation Manual page 43

Step 2: Press "Set" button to enter setting mode. "Max Setpoint" will flash to indicate setting mode.
Step 3: Press the "UP" or "DOWN" buttons to change the maximum setpoint value. This will limit the maximum setpoint
the user can select. Note: The maximum setpoint is approximately 180˚F.
Step 4: Press "Set" button to confirm new "Max Setpoint" value and stop setting mode.
Max
°F
Setpoint
idle
Operational
Status

SELECT SET
Max
°F
Setpoint

idle
Operational
Status
SELECT SET
Max
°F
Setpoint
idle
Operational
Status

SELECT SET
43
"Max Setpoint" Flashes
"Max Setpoint" continues to flash
while making adjustments
"Max Setpoint" stops flashing